STM32 Jobs

I am building a grid-tied solar inverter and need a seasoned embedded designer to deliver complete, production-ready firmware for both an STM32F103 and a TMS320F28035. The inverter must connect seamlessly to the grid, track maximum power from the panels, report its status remotely, and shut down safely if it detects islanding. To achieve this you will configure and optimise the following on the STM32: • ADC – fast sampling of panel and grid voltages/currents for control loops • PWM – generation of high-resolution switching signals for the full-bridge stage • UART – bidirectional link for remote monitoring, logging and field updates On the TMS320 you will implement the high-speed control algorithms (MPPT, PLL, anti-islanding logic, grid-synchronis...

PCB Design – STM32 I need an experienced PCB designer to create a 4-layer industrial PCB Requirements: * MCU: STM32 * 4G Module: SIM7600G (GPS + LTE) * Power: 12V → 5V (LM2596), 3.3V (AMS1117), battery backup * Inputs: 3× CT + 3× PT (with protection & filtering) * Output: Relay-based MCCB trip (optocoupler isolated) * Extra: MPU6050 (I2C), LEDs, buttons, UART debug Key Design Points: * 4-layer PCB (GND + power planes) * Proper HV/LV isolation (8mm clearance) * EMI/EMC-friendly layout * RF layout for 4G antenna (50Ω) Deliverables: * PCB design files (KiCad/Altium/EasyEDA) * Gerber + BOM + Pick & Place * Ready for manufacturing Looking for: * Experience in industrial PCB design * Knowledge of power + RF + protection circuits Apply with: * Simil...

I need my current water-level indicator rebuilt from the ground up so it does far more than just show a level. The new design must constantly monitor the tank, trigger automatic fill/stop routines, and run solely from a compact battery pack. I am open to whichever display technology you feel best suits the build—I mainly care that the read-out is clear, low-power, and robust enough for daily use. Scope of work From concept sketches to a working prototype, you will rethink the sensing method, control logic, power management, and housing. That includes choosing the ideal microcontroller, designing the PCB, writing the firmware, and packaging everything in an enclosure that can handle occasional splashes or condensation. The finished unit should be maintenance-friendly and easy for a n...

My motor-driven inspection robot already works, but its electronics and code now need a serious upgrade. The mobile unit talks to a control box through a 100-metre twisted-pair cable while a vision camera streams live video, so every watt saved and every microsecond trimmed matters. Phase 1 – Mobile Unit I want the existing PCB completely re-laid to improve thermal behaviour, noise immunity and overall robustness. You will analyse the current board, then redesign it for cleaner power distribution, better signal integrity and easier field service. Schematics, PCB files (Altium or KiCad preferred), BOM and production-ready Gerbers are expected. Phase 2 – Control Box Inside the controller several separate boards handle power, comms and motor control. I need these consolidate...