Cancelled

Ardu-chute

I want to make a R/C parachute system for my AR Drone 2.0.

Currently I have an arduino uno which has a push button on input A0 and this board sends out a serial value over a 433mhz tx from digital pin 2

I am recieving ok as watching the nano on the serial monitor

it sees the change from 0 to 1023 when I press and hold the button down for a little bit

I am very new to Arduino and have reached my current limits. So I seek your services and skills for what I would like to achieve below.

UNO- is transmitter end. I want sketch which will only transmit a character command "popchute" once a push button has been pressed, I want a LED output to go LOW when the button is pressed.

NANO- receiver end I want this to have 2 inputs as well as the recieved character command.

input 1- push switch once pressed arms parachute system and will allow output IF

input 2- is released (unpushed) (this happens once drone takes off/switch not making contact with the ground)

If command is received and inputs 1 has been armed and input 2 has gone low I want 2 output pins made high.

I hope this helps you see my vision?

Skills: Arduino, Electronics

See more: seek change, r seek, chute, drone services, a0, pin down, Nano, my ar, led push button, drone, arduino sketch, arduino current/, ardu, contact receiver, bit serial arduino, arduino nano parachute, arduino uno receiver, arduino command, sketch arduino, serial arduino, arduino serial bit, arduino bit, command arduino, arduino input, uno

About the Employer:
( 4 reviews ) Wellingborough, United Kingdom

Project ID: #4511982

1 freelancer is bidding on average $50 for this job

rajvigneshtn

Hired by the Employer

$50 USD in 4 days
(3 Reviews)
3.7