Ardu-chute. 433mhz wireless ardu parachute

I want to make a R/C parachute system for my rc plane.

Currently I have an arduino uno which has a push button on input A0 and this board sends out a serial value over a 433mhz tx from digital pin 2

I am recieving ok as watching the nano on the serial monitor

it sees the change from 0 to 1023 when I press and hold the button down for a little bit

I am very new to Arduino and have reached my current limits. So I seek your services and skills for what I would like to achieve below.

UNO- is transmitter end. I want sketch which will only transmit a character command "popchute" once a push button has been pressed, I want a LED output to go LOW when the button is pressed.

NANO- receiver end I want this to have 2 inputs as well as the recieved character command.

input 1- push switch once pressed arms parachute system and will allow output IF

input 2- is released (unpushed) (this happens once drone takes off/switch not making contact with the ground)

If command is received and inputs 1 has been armed and input 2 has gone low I want 2 output pins made high.

I hope this helps you see my vision?

I have used the virtual wire library and these modules-

Skills: Arduino, Electronics, Microcontroller

See more: arduino nano parachute, seek change, r seek, go wireless, chute, arduino uno microcontroller, drone services, a0, pin down, Nano, led push button, drone, arduino sketch, arduino current/, ardu, contact receiver, bit serial arduino, arduino uno receiver, arduino command, sketch arduino, serial arduino, microcontroller board, arduino serial bit, arduino bit, command arduino

About the Employer:
( 4 reviews ) Wellingborough, United Kingdom

Project ID: #4511994

Awarded to:


I am currently working on my quadrotor, and have a good idea about these systems. Please check your pm for more details.

$55 USD in 15 days
(0 Reviews)

3 freelancers are bidding on average $90 for this job


Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of ha More

$210 USD in 3 days
(14 Reviews)

Quite straight forward, happy to help. First thing I'd need is details of your wireless system.

$166 USD in 5 days
(0 Reviews)

Hi, i am eager to join your project.

$50 USD in 3 days
(0 Reviews)