Arduino program

Cancelled Posted 6 years ago Paid on delivery
Cancelled Paid on delivery

I need someone who can create arduino program using the existing RAMPS v1.4 boards that is being used for 3D printing (XYZ,EXT0,EXT2) ports with DRV8825 stepper driver to run multiple servo motors in one direction with specified steps at a time ...

example:

when z limit switch is ON run all Z axis motors (N steps or N Revolution)

when y limit switch is ON run all Y axis motors (N steps or N Revolution)

....and so on

motors will stop automatically after set of RUN instructions and wait for limit switch again for the next run.

I need to be able to used the LCD functions as a menu based to control these Motors to start and stop the program and set N steps or N Revolution) each routine. Can use the MARLIN firmware for 3D printing and modify it as a Control application.

example:

Run Menu

Run 1 ... run all motors (when activated) to run 1000 steps

Run 2 ... run all motors when activated for 1,500 steps

Run 3 .... 500 steps

attached are sample illustrations about the board and sample connections.

Arduino C Programming Electronics Microcontroller PLC & SCADA

Project ID: #16362569

About the project

2 proposals Remote project Active 6 years ago

2 freelancers are bidding on average $1056 for this job

binyameen441

javed .

$1111 AUD in 1 day
(33 Reviews)
4.8
Nges

A proposal has not yet been provided

$1000 AUD in 3 days
(1 Review)
0.6