I have a project with 2 micro controllers communicating over RS-232 and I have the need for a robust communications and command processing protocol on one of the microcontrollers (the slave device).
Commands are received between start and end markers < and > to ensure the full message is received before processing. eg: <command>
Your function must decode these requests and call the corresponding local function(s), which are being written by me.
You must also handle reading and writing several values to EEPROM on the ATMEGA328PB, which may be tricky according to my limited experience.
I will set up a development environment to use if you want, (access via Teamviewer) with an ATMEGA328PB board that you can program and test serial communications.
Code will be thouroughly tested by my team and must be bug-free.
Please see the attached files for requirements and expected code behavior. Thanks.
14 freelancers are bidding on average $239 for this job
Hello, I read your docs and understand. I have a lot of expirience with ATMEGA and serial communication. I have a development board and tools. Best regards, Vyacheslav.
I am professional electrical engineer i have years of experience of microcontroller and aurdino and i can complete the desired work before the time limit and minimum of your buget
I have work experience doing firmware developmentment. I have done work on arduino and atmega. I would like the opportunity to provide you the best product possible.