I'm planning to have my company logo lasercut into a metal plate and installed on a wall, sideways. On top there will be a single lightinh through the metal plate. On the wall there should be a image of the logo. I'm looking for a person to make the AI file of my logo so that it would appear on the wall close to the original, not distorted so much due to the shadow.
Logo should be as big as possible (at least 90cm wide)
The logo can be a little distorted, but not too much stretched out
At the moment the light is 30cm from the wall, but if it turns out that the end result cannot be very big with this size, then we have to get a new lamp and place it further from the wall.
Some additional 1mm support has to be added to the file to keep the logo together.
17 freelancers are bidding on average $24 for this job
Hi there! I'm interested in your project. You can send me a message so that we can discuss more. Regards, Arnold Stay tuned, I'm still working on this proposal.
Hi there, I can help you with your logo, but can you give me more info. Is the attached logo the logo you are talking about? Thanks! Relevant Skills and Experience adobe illustrator Proposed Milestones $30 USD - 30
Can deliver the project tomorrow Relevant Skills and Experience Graphic design, corel draw, adobe illustrator Proposed Milestones $25 USD - Logo prepared for laser engraving