Design PCB/Circuits
$250-750 USD
Paid on delivery
I need a circuit designed.
I need 6 relay outputs, 6 opto-isolated inputs, 2 Analog Inputs (1 suitable for RTD), 2 Analog Outs, A 4 pin connector for LCD display over i2C.
In fact everything above should be for I2C control.
Then I need some headers to a processor - pick some arduino this may change but again so far it should all be I2C so it shouldn't matter.
I want a power circuit that can take in just about any power source. Let's see what you can come up with here.
The processor needs to be optional - I am thinking DIp switches/jumpers to connect the I2C. All cards need to be on a bus so they can be daisy chained. So I can plug in 1 processor, connect another card and that processor controls it all. The card needs to be addressable for all the IO on it.
Also ADD some leds - 4 to 8 of them. small for diagnostics.
Project ID: #7951461
About the project
60 freelancers are bidding on average $540 for this job
hi sir i am an expert electrical engineer i can. do it for you please have a look at my profile i assure you quality work and on time delivery i have almost 4years of experience in this field please give me a chance to More
Hello, I am elecctronics and communication engineering. I have beenworking more than 6 years about embedded systems. I can send my PCB designs as referances. All the Best, Ali ŞERBETÇİ
Hello. If we think the same, you need a circuit board on which one group devices are located ( 6 relay outputs, 6 opto-isolated inputs, 2 Analog Inputs (1 suitable for RTD), 2 Analog Outs, A 4 pin connector for LC More
I am an Electrical Engineer having specialization in Electronics and Control, working as Lab Engineer at FAST National University Pakistan, at Electrical Department. Now a days i am also doing my MS degree in Electrica More
Hi, I am a post graduate power electronics engineer and having excellent design and development knowledge in power supplies,SMPS,DC-DC,AC-DC,Battery chargers design using different topologies like flyback,push pull,b More
Hi... I have 5+ years of experience in the field of electronics. I am working on different industrial based project where my primary role was to design embedded system, programming of micro-controller and pcb designing More
I have read and fully understood your requirements. Please open chat to discuss further….. =================+++++++++++++++++++++++++==================
I'm an Electronic Engineer, working with electronics circuits (digital, analog, mixed and of power) and embedded products with microcontrollers since 1996. My work as freelancer is my only work, so I work on the projec More
Do you want only the schematic and BOM, or you want PCB and Gerber files? The bid may change depending on your answer.
Good Day! I am writing this regarding your job posting "Design PCB/Circuits". After carefully reviewing your job specifications I feel that I a very suitable for you job. I've designed different circuit for different More
I can do this design, not sure what to write here. I have few questions, like what do you mean by the bus? If I understand correctly, you want to control your relays via the I2C? And other boards via the same I2C bus? More