Port Adafruit LED Matrix Library to STM32F103
$250-750 USD
Paid on delivery
We are looking for a freelancer that can quickly assist us in converting our copy of the LED Matrix library for use on the STM32F103. The Atmega328 chip can only support 1 32x32 matrix and we need to be able to support at least 4 of them. We are also on a tight deadline to complete this project. We are looking for someone who can develop the firmware and also assist in testing/debugging. If the project goes well, there are many other opportunities to work with us in the future. Max bid $300.
Project ID: #16454040
About the project
15 freelancers are bidding on average $351 for this job
Hi, I hope you are doing well. I have expertise in embedded system programming. I have worked on Arduino as well as STM32 boards and I have hardware available for quick testing of the code. I have worked with Neo More
Dear Sir, I am an expert with more than 15 years of experience in embedded systems, electronics, programming and firmware development. I assure you the best solution for your work. Regards Ch
Hello. I'm an embedded software engineer with extensive experience with Arduinos and STM32s. I often have to port Arduino libraries to the cheap STM32F103, my go-to MCU, so I'm quite proficient in that regard. I write More
I have long experience with 8-bit and 32-bit micro-controllers. I work with PIC , AVR , ST and NXP micro-controllers. I use KEIL IDE , Atmel Studio and MPLABX IDE . Regarding your project , I have worked lots with S More
I had good experience in LED matrix display programming and working experience in LED scrolling AD boards. 7 years of experience in embedded systems programming and hardware issue debugging. Good knowledge on STM and A More
I have experience in working with STM32F746G IC for GUI development. I have worked on A6 embedded workbench as well as IAR workbench with STM32F7 series. I have two years experience in the embedded system domain.
Dear Client, I hope that you find this in good health. I am placing this bid since I find my skills and previous experience, quite parallel to your project requirements. Following is the list of my experiences/skill More
I have been working with STM32f103 for 2 years. I have also worked with LED panels, I have some code for 1 color (red only) 16x32 P10 module.